![]() ![]() Recharge the battery by returning it to the base charge cradle for one to three hours until charge light stays lit or quits blinking. One beep every 10 seconds is caused by a low battery warning. Make sure the AC Power is plugged into the wall and then you can adjust the configuration setting to the clearest setting.Īlso see our Plantronics CS50/CS55 interactive setup guideīeeping Sounds from the Plantronics CS50/CS55: ![]() There is a switch towards the bottom on the right side of the base unit that will switch the IntelliStand feature On and Off. The IntelliStand feature senses when the headset has been removed or placed into the CS50 base unit which automatically activates the Handset Lifter and enabling headset/handset mode to answer or end the call. When the CS50 or CS55 is used in conjunction with the Plantronics HL10 handset lifter you can enable the IntelliStand feature. There is also a switch on the right hand side of the base which is your the IntelliStand feature. This is what you press to use the headset and or transfer the call from the headset back to the hand receiver. There is a silver button on the headset itself which is your “Talk button”. This needs to be set to the clearest setting. Whatever number is lined up with the notches it what setting you are on. There are notches to the right of this dial. This is a dark grey dial with a 1234 on it. There are also configuration settings on the left hand side of the base. The headset volume control also doubles as a mute switch if you press it in, instead of rocking it back and forth. This is the rocker volume wheel on the back of the headset (opposite of the microphone). You can fine tune this setting by using the volume control on the headset itself. The Master Receive setting is on the back of the base (below the picture of the microphone) there is a 1234 switch 1 being the highest setting and 4 being the lowest setting. You can fine tune this setting with the Plus (+) and minus (-) buttons on the back of the base that are above and below the picture of the microphone. A is the lowest and D is the highest setting. The Master Transmit controls are the ABCD switch settings on the bottom of the base. The Plantronics CS50 or Plantronics CS55 has both transmit (how you are heard) and Receive (how you hear) controls on the unit itself. Then take the short cable that came with the CS50 and plug it into the port on the base of the CS50 where the icon of the “telephone” is, Then plug the other end into where your “Handset” was on your existing telephone. Unplug the “Handset” from the base of your existing telephone and plug it into the Plantronics CS50 base unit where it has the icon of the “Handset”. One has an icon of a “Handset” and one has the icon of a “telephone”. Reconditioned CS55 covered by 90-day factory warranty and is returnable for refund for 30 days.On the bottom of the Plantronics CS50 or Plantronics CS55 base unit there are 2 ports. You can perform all of these functions while using the CS55 but you must do so by pressing the appropriate buttons on your telephone when back at your desk. Important Note: The following functions cannot be performed remotely: transfer calls, switch lines, dial a number, put call on hold. For remote answering capability, click here for the CS55 bundled with optional HL10 automatic handset lifter. This complete system includes everything you need to connect this device to your single- or multi-line corded desk telephone. Comes with 4 ear hooks (small, medium, large and bendable) as well as a headband with padded ear cushion. This Plantronics cordless headset is convertible, allowing you to wear it over-the-ear or over-the-head (as shown). Improved rechargeable battery provides up to 10 hours continuous talk time roam up to 300 feet from your base. Noise canceling microphone, ideal for busy offices and call centers. All the controls are inside the headset itself, eliminating the need for a belt clip remote control. Operates on 1.9GHz frequency DECT 6.0 for digitally secure conversations. ![]() The wireless CS55 is for use with corded telephones. If you would like the bundled set with HL10 lifter, please click here. This item does not include the HL10 lifter. All refurbished headsets include a 90-day replacement warranty and they are returnable for 30-days for refund if you are not satisfied for any reason. Rest assured this headset is as good as new, just not in original Plantronics product packaging. It has been factory inspected, tested, cleaned and includes a new battery as well as a brand new, sealed pack of ear hooks as well as a headband with new cushion. We also offer the reconditioned Plantronics CS55 wireless headset for those who prefer this model. Please click here to order the NEW Plantronics CS540. The Plantronics CS55 has been discontinued and replaced by the CS540. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |